Removing the rear wheel

  • Remove the axle nut cap
  • Remove the drive belt from the tensioner. The belt cannot be removed at this stage!
    The tension pulley that pushes the belt against the rear freewheel can be unscrewed.
    When removing the rear wheel, remember the order in which the nuts and washers were placed.
  • On the left side there are 2 nuts at the wheel, on the right side there is one nut.
  • They are placed in the following order. Left and right side of the rear wheel.
  • Then remove the plastic washer with the yellow marking from the hub.
  • After removal, this part will remain on the wire rope. Now the belt can also be removed.

Leave a Reply