- Careful, the stability of the construction will be decreased after removing the element, make sure that you control the position of the construction
- Using the above mentioned tools, slightly unscrew all the bolts and nuts holding the short Crossmember A at the bottom of the construction (4x)
- 1 repairer holds the Crossmember A firmly, while the second repairer removes by hand or using the tools the nuts, bolts and washers from the connection
- The component can now be removed
Note: You will need 2 sets of Ratchet (T001) + ratchet nut (T002). One of them can be also replaced by the ring spanner (T003).