Rack M1 1660 x 1160 mm

Step 1 Removal of the Dip bars (C009)

• The Dip bars are not connected to the construction by any fixing element, remove them by lifting the hanging part into a position from which you can remove the element and carefully place it to the ground

Step 2 Removal of rubber covers (C001)

• All of the nuts and bolts are covered by black rubber covers
• Remove them by grasping them firmly by 4 fingers
• To facilitate the process, you can use an auxiliary tool, for example a flat screwdriver or knife, to gently separate the cover from the construction

Step 3 Removal of the Multi Grab Bar (C008)

Tools: ratchet, ratchet nut

• Using the above mentioned tools, slightly unscrew all the bolts and nuts holding the Multi Grab Bar (4x)
• 1 repairer holds the Multi Grab Bar firmly, while the second repairer removes by hand or using the tools the nuts, bolts and washers from the connection
• The component can now be removed

Step 4 Removal of the CROSSMEMBER A, 1000 mm (C009)

Tools: ratchet, ratchet nut

• Careful, the stability of the construction will be decreased after removing the element, make sure that you control the position of the construction
• Using the above mentioned tools, slightly unscrew all the bolts and nuts holding the short Crossmember A at the bottom of the construction (4x)
• 1 repairer holds the Crossmember A firmly, while the second repairer removes by hand or using the tools the nuts, bolts and washers from the connection
• The component can now be removed

Step 5 Removal of the Triple bar (C007) + achieving the horizontal position

Tools: ratchet, ratchet nut

• Careful, after removing this element the construction will lose its stability, make sure there is one person (if skilled and strong, otherwise 2 persons) holding the construction in position, until this step has been finished
• Using the above mentioned tools, slightly unscrew all the bolts and nuts holding the Triple bar (4x)
• 1 repairer holds the Triple bar firmly, while the second repairer removes by hand or using the tools the nuts, bolts and washers from the connection
• The component can now be removed by 1 person, while the other person holds the 2 remaining frames in their original position
• The first repairer than carefully pulls the frames to the ground- one by one, to assure an easy access and safe disassembly of the rest of the construction

Step 6 Removal of the remaining components: Single bar 1500 mm, Yellow (C006): 2x, CROSSMEMBER B, 1500 mm (C010): 2x, CROSSMEMBER A, 1500 mm (C010): 2x

Tools: ratchet, ratchet nut

• Using the above mentioned tools, slightly unscrew all the bolts and nuts of the selected element (4x)
• Remove by hand or using the tools the nuts, bolts and washers from the connection, the second repairer can still hold the element in position to ease the process
• The component can now be removed
• Repeat with all components (6x)

Step 7 Removal of the Leg pro, 2500 mm (C013)

• After finishing the previous steps, the Leg pro components are left free.

Step 8 Finished

• The disassembly is now finished.
• You can reassemble the product following the steps in reverse order.